Engine Serial: 275,484 and up
Bore: 4.02 in (102 mm)
Pin Diameter: 1.375 in (35mm)
Liner O-Rings sit in grooves inside cylinder block in this application. There are no o-ring grooves in the cylinder liners.
Connecting rod marked: R51727, R80034
Standard Compression Piston marked: RE53265, AR77762
Cylinder Kit: AR78041, RE53321, AR71592
Block Casting: T32342, R55011, R55034 or R72972
Piston Specifications:
Bore Diameter: 4.02"
Piston Length: 4.38"
Piston Pin Diameter: 1.375"
Piston Pin Part Number: 2231901
Compression Distance: 2.609"
Compression Ring Groove 1: 1-1/8"
Oil Ring Groove Width 1: 13/64"
Sleeve Specifications:
Bore Diameter: 4.020"
Flange Outer Diameter: 4.920"
Flange Width: 0.238"
Sleeve O.D. at Pilot: 4.685"
Sleeve O.D. at Barrel: 4.637"
Sleeve Outer Diameter at Seal: 4.371"
Length: 7.72"
Firewall: 0.0285"
Sleeve Type: Wet
Agricultural: 499, 1035, 1130, 1635, 2030, 2035, 2120, 2270, 2280, 2320, 2440, 2530, 3300
Construction: 310, 410, 310B, 401B, 401C, 401D, 410B, 440B, 450C, 450D, 455D, 480B, 480C, 540B
Inframe Kit Includes:
(4) Cylinder Kits (Piston, Liner, Piston Rings, Piston Pin, Pin Retainers), O-Rings in Block
(4) Rod Bearing Pairs
(1) Main Bearing Set
(1) Head Gasket Set
(1) Oil Pan Gasket
(8) Rod Bolts
Overhaul Kit Includes:
(4) Cylinder Kits (Piston, Liner, Piston Rings, Piston Pin, Pin Retainers), O-Rings in Block
(4) Rod Bearing Pairs
(1) Main Bearing Set
(1) Overhaul Gasket Set
(8) Rod Bolts
(1) Fuel System Grommet Set
(1) Rear Crankshaft Seal
(1) Front Crankshaft Seal
(4) Piston Pin Bushings
(6) Balance Shaft Bushings*
*If you are replacing the balance shaft bearings in this kit, you will need to swedge these bushing once installed. This requires a special tool (John Deere Service Guard # JD255-1)
Cross Reference with Kit Numbers RP175, RP206